Skip To Content
Flex Shot

Flex Shot Thick Rubber Adhesive Sealant Caulk – White

8 oz
$17.93 each($2.24 / oz)

Aisle 24

Victoria H‑E‑B plus!
6106 N. NAVARRO

Description

Flex Shot is a thick, rubberized paste that fills cracks and holes. It’s the easy way to caulk, bond & seal. Leak proof seal! Excellent for kitchens and baths, sinks and showers, tubs and tiles, and windows and skylights. Also works well on roofs and gutters, autos and boats, RV's and campers, PVC pipes, and duct work –anywhere you need a tight, leak proof seal & strong bond! Perfect bead every time! It dries to a tough, flexible, watertight seal.

Color: White

  • Ingredients

    Dimethyl siloxane, hydroxyterminated, Silica, amorphous, Hydrotreated middle petroleum distillates, Ethyltriacetoxysilane, Methyltriacetoxysilane, Difluoroethane

    Allergens and safety warnings

    Caution: Causes skin irritation. Contents under pressure. Contains flammable propellant. Read rear panel for other cautions! Keep out of reach of children. Uncured sealant causes irritation on contact with skin and eyes. In case of contact with skin, wipe off with paper towels or cloth and wash with soap and water.
    In case of eye contact, immediately flush with water for 15 minutes. Call a physician immediately. Use with adequate ventilation. Contents under pressure. Do not puncture or incinerate. Do not remove rubber plug. Do not store at temperatures above 120 degrees F. Do not store in automobiles, in direct sunlight, or any area with temperatures above 120 degrees F. Keep container away from heat, sparks and flame. See Material Safety Data Sheet. Contains gas under pressure: May explode if heated. Causes serious eye and skin irritation.

    Prevention: Wear protective gloves. Wear eye or face protection. Wash hands thoroughly after handling.
    Response:
    If on Skin: Wash with plenty of soap and water. Take off contaminated clothing. Wash contaminated clothing before reuse. If Skin Irritation Occurs: Get medical attention.
    Storage: Protect from sunlight. Store in a well-ventilated place.

  • 1. All surfaces must be clean, dry and free from dirt, grease and oil.

    2. Hold can at 45-degree angle, push against the nozzle side and apply into the joint or seam to obtain full contact between surfaces.

    3. Flex Shot can be smoothed within 5 minutes of application. Remove excess immediately with a dry paper towel.

    4. Sealant forms a tack free skin in 20 minutes. Length of full cure depends upon factors such as temperature and humidity, but sections up to 1/8 inch become rubbery solids in about 24 hours.

    5. After using, extend a small amount of material beyond the end of the nozzle. This will cure and form a seal for the remaining material. Pull out this cured plug when you are ready to use again.

Similar items