Promoted
1/6
Lysol
Lysol Disinfectant Spray, Sanitizing Antibacterial Spray, Early Morning Breeze
12.5 oz
$6.21 each($0.50 / oz)
Aisle 17
Victoria H‑E‑B plus!
6106 N. NAVARRO
Description
Lysol Disinfectant Spray kills 99.9% of bacteria and viruses, including cold, flu, and coronavirus (when used as directed). This disinfectant spray sanitizes, disinfects and eliminates odors. Use this disinfecting spray on high touch hard surface areas. Let Lysol bring you and your family peace of mind when it comes to disinfecting against germs. You can also use this disinfecting spray on soft surfaces, like couches, coats, sports bags, strollers and backpacks.- DISINFECTANT SPRAY KILLS 99.9% OF VIRUSES AND BACTERIA: Lysol Disinfectant Spray is tested and proven to kill 99.9% of viruses and bacteria, including COVID-19/Coronavirus (when used as directed), EPA Reg 777-99- ANTIBACTERIAL BLEACH-FREE DISINFECTANT : this Lysol disinfecting product should work as hard as you do, this household disinfectant kills over 100 illness causing germs, including cold and flu viruses. (when used as directed)- DISINFECTING SPRAY FOR GERMS: This disinfecting spray eliminates messes and 99.9% of germs and odor causing bacteria- SANITIZING SPRAY FOR HARD AND SOFT SURFACES: This fast-acting spray disinfects hard non-porous contact surfaces and sanitizes surfaces- LEADERS IN DISINFECTION: Looking for some of our other best household disinfectant cleaning products,Try Lysol Disinfectant Cleaning Wipes, Lysol All Purpose Cleaners, and Lysol Bathroom Cleaners (packaging may vary)
Ingredients
Active Ingredients: Alkyl (40% C12, 50% C14.10% C16), Dimethyl Benzyl Ammonium Chloride(0,960%), Octyl Decyl Dimethyl Ammonium Chloride (0,720%), Didecyl Dimethyl Ammonium Chloride (0,288%), Didecyl Dimethyl Ammonium Chloride (0,432%), Other Ingredients: (97,600%), Total: (100,000%)Allergens and safety warnings
KEEP OUT OF REACH OF CHILDREN PRECAUTIONARY STATEMENTS: Hazards to Humans and Domestic Animals CAUTION: Causes moderate eye irritation. Do not spray in eyes, on skin or on clothing. Wash thoroughly with soap and water after handling and before eating, drinking, chewing gum, using tobacco or using the toilet. PHYSICAL HAZARDS: FLAMMABLE. Contents under pressure. Keep away from heat, sparks and open flame. Do not puncture of incinerate container. Exposure to temperature above 130º F may cause bursting. FIRST AID: If in eyes - Hold eye open and rinse slowly and gently with water for 15-20 minutes. Remove contact lenses, if present, after the first 5 minutes, then continue rinsing eye. Call a Poison Control Center or doctor for treatment advice. CONTACT NUMBER: Questions? Comments or In case of an emergency, call toll free 1-800-228-4722. Have the product container or label with you when calling a Poison Control Center, or doctor, or going for treatment.- One Can many surfaces Kitchen: • Sinks • Garbage cans Bathroom: • Bathtubs • Shower Home: • Door knobs • Diaper pails Soft Surfaces: • Mattresses • Sofas DIRECTIONS FOR USE: It is a violation of Federal law to use this product in a manner inconsistent with its labeling. Read the entire label before using the product. Pre-clean surfaces prior to use. Hold can upright 6" to 8" from surface. Spray 3 to 4 seconds until covered with mist. - To Deodorize: Spray on surfaces as needed. - To Sanitize: Surfaces must remain wet for 10 seconds then allow to air dry. - To Disinfect: Surfaces must remain visibly wet for 3 minutes then allow to air dry. For Hepatitis A virus, Adenovirus 2, Fusarium solani and Mycobacterium bovis BCG at 20°C (68°F) surfaces must remain visibly wet for 10 minutes then allow to air dry. Rinse toys and food contact surfaces with potable water after use. - Fabric Sanitizer: For spot treatment (2" x 2" area) only. - To Sanitize Soft Surfaces: Spray until wet. DO NOT SATURATE. Leave for 30 seconds to sanitize. Air dry. For difficult odors, repeat application. - To Disinfect Soft Surfaces: Spray until wet. DO NOT SATURATE. Leave for 10 minutes to disinfect. Air dry. For difficult odors, repeat application. - To Control and Prevent Mold and Mildew: Apply to pre-cleaned surface. Allow to remain visibly wet for 3 minutes. Let air dry. Repeat applications in weekly intervals or when mold and mildew growth appears. Do not use on polished wood, painted surfaces, leather, rayon fabrics, or acrylic plastics. Do not use on silk, rayon acetate or satin fabrics. Always test on a hidden area of fabric.