The number of items in your shopping list has exceeded the maximum limit. Please remove some items, or create a new shopping list.
Oops. This product is only available in a minimum quantity of or more units
Roll over image to zoom in

Fix A Flat Inflator & Sealer

Item is no longer available.
Product Description

Non-flammable formula. Everyone gets a flat. Be prepared! No jacks or tools required. Seals and inflates in minutes. Patented proprietary rubber compound provides a durable seal on contact. For use on passenger cars, vans, light truck, trailers, lawn tractors and ATVs. Do not use in bicycle high performance, Z-rated or motorcycle tires. Made in U.S.A.

Preparation Instructions

Read warnings before use. Wear protective eye wear during use (safety goggles, eyeglasses, sunglasses, etc). If temperature is below 32 degrees F, warm can using vehicle's interior heater vent before use. 1. If possible, remove foreign objects from flat tire. 2. Shake can vigorously for 30 seconds before screwing nozzle onto tire valve. 3. If possible, move car slightly so that tire valve is in the 6 o'clock position. Screw plastic nozzle onto tire valve with can upside down and vertically aligned to the tire valve stem. Contents of can will automatically discharge into tire. 4. (Rate slows as tire inflates.) After can has discharged, unscrew nozzle. 5. Watch to make sure tire rim lifts off ground. 6. Only if rim is off ground, drive vehicle immediately a short distance (2 to 4 miles) to allow tire pressure to increase and sealant to spread evenly inside the tire.

Safety Warning
Precautionary Measures: Use only per label directions. Do not inhale. Use in a well ventilated area. Do not use indoors. Avoid contact with eyes. Do not puncture or incinerate container. Do not expose to heat, open flame, direct sunlight or store at temperatures above 120 degrees F. Exposure to heat may cause can to rupture. Do not store in interior of car (including glove compartment and inside hatchbacks). Temperature inside car can exceed 120 degrees F. Store outside passenger area of vehicle, preferably secured in spare tire well or trunk. Do not use with any other tire inflator products. Do not use on motorcycle or bicycle tires. Failure of one tire could cause loss of control. Also do not use on high performance or Z-rated tires. Do not use Fix-a-Flat with tires that utilize tire sensor technology. Fix-a-Flat may block tire sensors and cause them to be inoperable. Fix-a-Flat will not be a liable for damage to tire sensors. Never weld on a rim. Welding on a rim with the tire mounted could cause the tire to explode regardless of whether tire inflators is used. Welded and repaired rims are unsafe. First Aid: Contains fluorocarbons and aromatic solvents. Inhalation: If inhaled, breathe fresh air. If breathing is affected, give artificial respiration and call a physician. Eye Contact: Immediately flush with water for 15 minutes. If irritation persists, call physician. Ingestion: If ingested, do not induce vomiting. Call physician immediately. Keep out of reach of children.
Actual product packaging and materials may contain more or different information than that shown on our website. You should not rely solely on the information presented here. Always read labels, warnings and directions before using or consuming a product. View full Product Information Disclaimer


Tell us what you think!
Tell us what you think!
Be the first to write a review!
Wondering what to say?
  • Include usage tips, key benefits, and helpful suggestions.
  • Did you have a good or bad experience?
  • Would you recommend this to friends or family?
  • Be respectful to others.
{{review.commentTitle}} {{review.timestampFormatted}}
by {{review.sender.screenName}} {{review.sender.screenName ? review.sender.screenName : 'Anonymous'}}
Was this review helpful to you? Yes {{review.posVotes}} No {{review.negVotes}} Flag
Customer Relations